Lbl-lighting LED Illum MO Flush Elec Xfmr 60w 277v/12v LED Manuel d'utilisateur télécharger pdf

Installation Instructions for

60 Watt Electronic Flexible Power Feed

Canopy Transformer

980MRLSFELEDFCT-LED

1.2

TRANS-SFE60_-LED

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed only when all the products used are

supplied by LBL Lighting, is suitable only for indoor dry locations

and approved for use at any height above the finished floor.

This product may be dimmed only with a low voltage electronic

dimmer. Using a dimmer not designed for low voltage electronic

applications may cause undesirable noise and potentially shorten

the life of the transformer.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

This product is intended for use with LBL low voltage lighting

systems only.

Read all instructions thoroughly before beginning installation.

The overall fixture height (H) is measured from top of the

canopy to the bottom of the power feed. Leave an additional

4” of the coaxial cable for connecting to power.

Once the height is determined, cut the excess coaxial cable.

(H)

POWER FEED

HOUSING

NOTE: It is recommended to adjust the power feed

height before installing the canopy.

CANOPY

Adjust the Fixture Height

Important Safety Information

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than 6 inches to curtains or

similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load the circuit of the surface mount transformer to no more than

the maximum rated capacity as specified.

LED-Illuminated Monorail

1A1A

1 2 3 4

Résumé du contenu

Page 1 - Important Safety Information

Installation Instructions for60 Watt Electronic Flexible Power FeedCanopy Transformer980MRLSFELEDFCT-LED11.2TRANS-SFE60_-LEDGP I :ENERAL RODUCT NFORMA

Page 2

2Feed the coaxial cable up and into the canopy post.Slide the metal sleeve up into the canopy post and secure bytightening the M4 set screw with the p

Page 3 - Install the Power Feed Canopy

3Connect the MonoRailRemove the power feed cap from the power feed housing.Completely back out the screw on the power feed cap.NOTE: The standoffs sho

Page 4 - SAVETHESE INSTRUCTIONS!

4Tighten the screw on the power feed cap for proper powerconnection.POWERFEED CAPSCREWPlace the Monorail into the standoffs and power feed housings.Sc

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting LED Illum MO Flush Elec Xfmr 60w 277v/12v LED Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting LED Illum MO Flush Elec Xfmr 60w 277v/12v LED. LBL Lighting LED Illum MO Flush Elec Xfmr 60w 277v/12v LED User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting LED Illum MO Flush Elec Xfmr 60w 277v/12v LED