Lbl-lighting MO Direct Feed Standoff for Surf Xfmr Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting MO Direct Feed Standoff for Surf Xfmr. LBL Lighting MO Direct Feed Standoff for Surf Xfmr User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Installation Instructions for
Telescoping Rigid Standoff for Surface Mount Transformers
1.1
HANGERDIRADJ_1
980MRLSPSMT
1
Install the Rigid Standoffs
ANCHOR
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product is intended to be used with LBL surface mount
transformers and Monorail system only.
Select a location on the ceiling where the Monorail is to be
mounted.
One way of marking the standoff locations on the ceiling is to
lay the Monorail on the floor underneath of the selected
location and by using a plumb bob pointing on the center of
the Monorail, mark the points on the ceiling.
The other way is to hold the Monorail directly against the
ceiling and mark the standoff points on the ceiling.
Tap the anchors at the marked points up to the threaded
portion with a hammer.
Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple.
Repeat step 4 through 6 for the remaining standoffs.
CAUTION: This standoff is not applicable with
vaulted ceilings.
CEILING
Screw the anchors in the rest of the way with a Phillips
screwdriver.
ANCHOR
WASHER
#8 SCREW
THREADED NIPPLE
Monorail
1B
1A
1
2
3
4
6
5
4
6
1B
1A
5
7
1B1C
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Install the Rigid Standoffs

Installation Instructions forTelescoping Rigid Standoff for Surface Mount Transformers1.1HANGERDIRADJ_1980MRLSPSMT1Install the Rigid StandoffsANCHORGP

Page 2 - Adjust the Standoff Height

Loosen the M4 set screw on the support(Do Not Remove)post with the provided 2 MM Allen wrench and remove thesupport post.2SUPPORT POST2 MM ALLENWRENCH

Page 3

Remove the housing cap on all standoffs.HOUSING CAPPlace a section of the Monorail into standoff housings.While supporting the Monorail, tighten the h

Page 4 - SAVETHESE INSTRUCTIONS!

47400 Linder Ave, Skokie, IL 60077800.323.3226 - 847.626.6300www.lbllighting.com© 2014 LBL Lighting.All rights reserved.The "LBL Lighting"

Commentaires sur ces manuels

Pas de commentaire