Lbl-lighting LED Illum MO Surf Mag Xfmr 600w 277v/12v Manuel d'utilisateur télécharger pdf

Installation Instructions for

12 Volt 600 Watt Dual Power Feed

Magnetic Surface Mount Transformers

1.2

TRANS-SFM600-SC-LED_

980MRLDFM60SMT-LED

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed only when all the products used are

supplied by LBL Lighting, is suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage magnetic

applications may cause undesirable noise and potentially shorten

the life of the transformer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

Important Safety Information

Do not conceal or extend bus bar conductors through a building

wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains

or similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load each circuit of the surface mount transformer to no more

than the maximum rated capacity as specified.

LED-Illuminated Monorail

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1 2 3 4

Résumé du contenu

Page 1 - Important Safety Information

Installation Instructions for12 Volt 600 Watt Dual Power FeedMagnetic Surface Mount Transformers1.2TRANS-SFM600-SC-LED_980MRLDFM60SMT-LED1GP I :ENERAL

Page 2 - Adjust the Power Feed Height

2Adjust the Power Feed HeightThe overall length of the transformer (from top of thetransformer to bottom of the power feed connectors) is 40".Th

Page 3 - Install the Transformer

Loosen the three #8-32 flat head screws(Do Not Remove)with the provided 3/32 Allen wrench.Rotate the backplate counter clockwise so that the #8-32 fla

Page 4 - SAVE THESE INSTRUCTIONS!

4Hook the transformer safety wire onto the backplate bracket.Connect the backplate green wire to the ground in accordancewith local electrical codes.C

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting LED Illum MO Surf Mag Xfmr 600w 277v/12v Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting LED Illum MO Surf Mag Xfmr 600w 277v/12v. LBL Lighting LED Illum MO Surf Mag Xfmr 600w 277v/12v User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting LED Illum MO Surf Mag Xfmr 600w 277v/12v