Lbl-lighting LED Illum MO Surf Elec Xfmr 60w 277v/12v LED Manuel d'utilisateur télécharger pdf

Installation Instructions for

1.3

TRANS-SFE61/100_-LED

980MRLSFELEDFSMT-LED

GP I :ENERAL RODUCT NFORMATION

This instruction is for the following models:

60 Watt Electronic Single Power Feed Surface Mount

Transformer (TRANS-SFE61_-LED)

100 Watt Electronic Single Direct Power Feed Surface Mount

Transformer (TRANS-SFE100_-LED)

This product is ETL listed only when all the products used are

supplied by LBL Lighting, is suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage electronic

dimmer. Using a dimmer not designed for low voltage electronic

applications may cause undesirable noise and potentially shorten

the life of the transformer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly before beginning installation.

60 & 100 Watt Electronic Single Power Feed Surface

Mount Transformers

Important Safety Information

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than 6 inches to curtains or

similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load the circuit of the surface mount transformer to no more than

the maximum rated capacity as specified.

To reset the electronic surface mount transformer, turn the power

off then on (main power, breaker panel, or wall switch).

LED-Illuminated Monorail

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1 2 3 4

Résumé du contenu

Page 1 - Mount Transformers

Installation Instructions for1.3TRANS-SFE61/100_-LED980MRLSFELEDFSMT-LED1GP I :ENERAL RODUCT NFORMATIONThis instruction is for the following models:60

Page 2 - Adjust the Power Feed Height

2Adjust the Power Feed HeightThe overall length of the transformer (from top of thetransformer to bottom of the power feed connector) is 41.5”.The tra

Page 3 - Install the Transformer

3Install the TransformerRemove the screws on the side of the transformer domecover and lift the cover off of the backplate.SCREWDOMECOVERBACKPLATEConn

Page 4 - SAVETHESE INSTRUCTIONS!

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting LED Illum MO Surf Elec Xfmr 60w 277v/12v LED Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting LED Illum MO Surf Elec Xfmr 60w 277v/12v LED. LBL Lighting LED Illum MO Surf Elec Xfmr 60w 277v/12v LED User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting LED Illum MO Surf Elec Xfmr 60w 277v/12v LED