Lbl-lighting MO Rmt Mag Xfmr 600w 277v/12v Manuel d'utilisateur télécharger pdf

Installation Instructions for

TRANSFORMERS

1.0

1.5

250AT600T277

950RM60012-277

Important Safety Information

Do not conceal or extend bus bar conductors through a

building wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can

be shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to

curtains or similarly combustible materials.

Turn the electrical power off before modifying the lighting

system in any way.

The fixtures used with the system must be identified for use

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches

(98 cubic centimeters).

To Reduce Risk of Fire, it is important to wire the remote

transformer for the system as described in this installation

instruction.

Load each circuit of the remote transformer to 300MAXIMUM

Watt.

277 Volt to 12 Volt Dual Feed 600W Remote Magnetic

Transformers

GP I :ENERAL RODUCT NFORMATION

This transformer is ETL listed for use with low voltage lighting

systems of brands offered by Generation Brands.

This product is suitable only for indoor dry locations and

approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with the local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage

magnetic applications may work initially, but could eventually

cause transformer failure and will void the warranty.

The

dimmer must be derated as indicated by the dimmer

manufacturer.

This product is intended for use with Generation Brands low

voltage lighting system brands only.

During installation, make sure all power connections are tight.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1 2 3 4

Résumé du contenu

Page 1 - Important Safety Information

Installation Instructions for1TRANSFORMERS1.01.01.5250AT600T277950RM60012-277Important Safety InformationDo not conceal or extend bus bar conductors t

Page 2 - LOW VOLTAGE WIRE SIZE TABLE

2Install the Remote TransformerMount the transformer to a solid surface using thekeyhole slot on the mounting bracket (hardware notincluded).Remove th

Page 3 - TERMINAL TAP TABLE

COMX X1 X2 X3 X4COMY Y1 Y2 Y3 Y43Install a conduit from the transformer to the electricalbox.For the best performance, use the "Low Voltage WireS

Page 4 - Check the System

4Check the SystemCOMX X1 X2 X3 X4COMY Y1 Y2 Y3 Y410111213PHILLIPSSCREWCIRCUIT BREAKERCIRCUITBREAKERSAVE THESE INSTRUCTIONS!123444337400 Linder Ave, Sk

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting MO Rmt Mag Xfmr 600w 277v/12v Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting MO Rmt Mag Xfmr 600w 277v/12v. LBL Lighting MO Rmt Mag Xfmr 600w 277v/12v User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting MO Rmt Mag Xfmr 600w 277v/12v