Lbl-lighting MO Surf Elec Xfmr 150w 120v/12v Manuel d'utilisateur télécharger pdf

Installation Instructions for

Monorail

Important Safety Information

Do not conceal or extend bus bar conductors through a building

wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains

or similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load the circuit of the surface mount transformer to no more than

the maximum rated capacity as specified.

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWERTO THE

ELECTRICAL BOX OFF.

1.6

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed only when all the products used are

supplied by LBL Lighting, is suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage electronic

dimmer. Using a dimmer not designed for low voltage electronic

applications may cause undesirable noise and potentially shorten

the life of the transformer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

12 Volt 150 Watt Single Power Feed

Electronic Surface Mount Transformer

TRANS-SFE150_

980MRLSFE15SMT

1 2 3 4

Résumé du contenu

Page 1 - Important Safety Information

Installation Instructions forMonorail1Important Safety InformationDo not conceal or extend bus bar conductors through a buildingwall.Do not install th

Page 2 - Adjust the Height

2CROSSBAR#8-32 FLATHEAD SCREWRemove the two #8-32 flat head screws to remove thecrossbar.#8-32SCREWCROSSBARMount the crossbar to the electrical box wi

Page 3 - Install the Transformer

3Properly place the wires and wire nut connections into thetransformer housing and slide the transformer onto thecrossbar.Align the transformer holes

Page 4 - SAVE THESE INSTRUCTIONS!

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting MO Surf Elec Xfmr 150w 120v/12v Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting MO Surf Elec Xfmr 150w 120v/12v. LBL Lighting MO Surf Elec Xfmr 150w 120v/12v User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting MO Surf Elec Xfmr 150w 120v/12v