Lbl-lighting MO Rmt Mag Xfmr 75w 277v/12v Manuel d'utilisateur télécharger pdf

Installation Instructions for

277 Volt to 12 Volt Single Feed 75W Remote Magnetic

Transformers

950RM07512-277

TRANSFORMERS

GENERAL PRODUCT INFORMATION:

This transformer is ETL listed for use with low voltage lighting

systems of brands offered by Encompass Lighting Group.

This product is suitable only for indoor dry locations and

approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with the local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage

magnetic applications may work initially, but could eventually

cause transformer failure and will void the warranty.

This product is intended for use with Encompass Lighting

Group brands of low voltage lighting systems only.

During installation, make sure all power connections are tight.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

The

dimmer must be derated as indicated by the dimmer

manufacturer.

Important Safety Information

Do not conceal or extend bus bar conductors through a

building wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can

be shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to

curtains or similarly combustible materials.

Turn the electrical power off before modifying the lighting

system in any way.

The fixtures used with the system must be identified for use

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches

(98 cubic centimeters).

, it is important to wire the remote

transformer for the system as described in this installation

instruction.

Load the circuit of the remote transformer to 75

Watt.

To Reduce Risk of Fire

MAXIMUM

CAUTION: RISK OF FIRE

This product requires installation by qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

1.2

250AT075T277

1 2 3 4

Résumé du contenu

Page 1 - Important Safety Information

Installation Instructions for277 Volt to 12 Volt Single Feed 75W Remote MagneticTransformers950RM07512-277TRANSFORMERSGENERAL PRODUCT INFORMATION:This

Page 2 - LOW VOLTAGE WIRE SIZE TABLE

2COM X1 X2 X3 X4Install the Remote TransformerNOTE: In order to use small gage wires from thetransformer to the electrical box, it is recommended toin

Page 3 - TERMINAL TAP TABLE

3COM X1 X2 X3 X4Install a conduit from the transformer to the electricalbox.For the best performance, use the "Low Voltage WireSize Table" o

Page 4 - Check the System

4Check the SystemCOM X1 X2 X3 X4After installing the entire low voltage system, if thelamps have low intensity, then measure the voltage atthe fixture

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting MO Rmt Mag Xfmr 75w 277v/12v Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting MO Rmt Mag Xfmr 75w 277v/12v. LBL Lighting MO Rmt Mag Xfmr 75w 277v/12v User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting MO Rmt Mag Xfmr 75w 277v/12v