Lbl-lighting Bling P Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting Bling P. LBL Lighting Bling P User Manual [de] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWERTO THE
ELECTRICAL BOX OFF.
Fusion Jack
Installation Instructions for
Bling
1.2
HS447_
980FSJBLNGP
Adjust the Fixture Height
1
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
Back out (do not remove) the set screw on the conical
connector with the provided Allen wrench.
SET SCREW
ALLEN WRENCH
2
1A
1B
2
1
1C
Tap the conical connector on a hard surface with the set screw
facing down, so the plate inside drops into place.
SURFACE
Cut the coaxial cable to the desired length.
Gently twist the end of the coaxial cable between thumb and
forefinger.
4
PLATE
3
4
1D
5
SET SCREW
ALLEN WRENCH
1
CONNECTOR
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Adjust the Fixture Height

GP I :ENERAL RODUCT NFORMATIONThis product is ETL listed and suitable only for indoor dry locationsand approved for use at any height above the finish

Page 2

21E6Feed and push the coaxial cable into the conical connector.Thecoaxial cable will come to a stop point after being inserted3/4" into the conic

Page 3 - Replace the Lamp & Shade

GLASSSHADELAMPGently remove the glass shade and old lamp from the socketassembly.LAMPPush the lamp pins completely into the socket holes.NOTE: Use onl

Page 4 - SAVETHESE INSTRUCTIONS!

SOCKETReplace and push the glass shade completely onto thespring clip.SPRING CLIPGLASS SHADE47400 Linder Ave, Skokie, IL 60077800.323.3226 - 847.626

Commentaires sur ces manuels

Pas de commentaire