Lbl-lighting Mini-Rhythm Manuel d'utilisateur télécharger pdf (Page 2)

Adjust the Fixture Height

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

SET SCREW

ALLEN WRENCH

SET SCREW

ALLEN WRENCH

CONNECTOR

Tap the conical connector on a hard surface with the set screw

facing down, so the plate inside drops into place.

SURFACE

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb and

forefinger.

PLATE

Feed and push the coaxial cable into the conical connector. The

coaxial cable will come to a stop point after being inserted

3/4" into the conical connector.

CONICAL CONNECTOR

OUTER WRAPPED

WIRE STOPS HERE

INNER WIRE

STOPS HERE

Keep pushing the coaxial cable into the connector while

rotating the connector to ease feeding the inner wire into the

tip of the connector. The outer wrapped wire will start

wrinkling while being inserted another 1/2" into the connector.

WRINKLE ON OUTER

WRAPPED WIRE

Look into the sight hole on the top of the connector to make

sure that the inner wire is contacting the end of the connector.

Hold the coaxial cable in place and tighten the set screw on tip

of the connector with the provided Allen wrench. Make sure

this set screw connection is tight.

SIGHT HOLE

ALLEN WRENCH

INNER WIRE

1 2 3 4

Pas de commentaire

Lbl-lighting Mini-Rhythm Manuel d'utilisateur Page 2