Lbl-lighting MILO S Manuel d'utilisateur télécharger pdf (Page 2)

CORD

CANOPY

Adjust the fixture height (from bottom of the fixture

shade to top of the canopy) by moving the canopy and

strain relief up or down.

When the desired height is achieved, tighten the set

screw on the strain relief.

Mark the cord underneath the strain relief.

Assemble the Fixture

Feed the canopy, cord, and socket assembly through the

shade.

Simultaneously pull the cord upward while carefully

lowering the shade onto the stopper.

CORD

SHADE

CANOPY

SOCKET

ASSEMBLY

CORD

SHADE

STOPPER

Install the Fixture

Leave 6" of the cord behind the canopy for power

connections. Cut the excess cord.

From the end of the cord, strip the insulation 4" using a

sharp knife. .Make sure not to nick the inner wires

Strip the end of the wires.

SET SCREW

Loosen the set screw on the strain(Do Not Remove)

relief.

1 2 3 4

Pas de commentaire

Lbl-lighting MILO S Manuel d'utilisateur Page 2