Lbl-lighting Linea Manuel d'utilisateur télécharger pdf (Page 2)

Push the anchors into the marked points on the wall up to the

threaded portion.

Screw the anchors in the rest of the way with a Phillips

screwdriver.

ANCHOR

MARKED POINT

Feed the power line wires through the round plate center hole,

backplate center hole, lock washer, washer, and nipple.

Slide the round plate and backplate onto the nipple attached to

the crossbar. Level the backplate horizontally and line up the

end holes with the anchors.

Tighten the nut to secure the round plate and backplate in

place.

ANCHOR

END HOLE

BACKPLATE

ROUND PLATE

LOCK WASHER

WASHER

NUT

SOCKET HOUSING

Connect the black fixture wire to the hot power line wire with

a wire nut.

Connect the white fixture wire to the neutral power line wire

with a wire nut.

SOCKET HOUSING

Place all wires and wire nut connections into the socket

housing.

Push the two #8 screws through the screw hole next to the

each socket.Tighten the screws to the anchors through the

end holes in backplate.

END HOLE

SOCKET

#8 SCREW

BACK PLATE

SOCKET

LAMP CONTACT

Use 120 Volt, Watt Type Linestra IncandescentMAX 60

Single Contact Double S14S Base Lamp With Model

LN60SI.

Use 120 Volt, Watt Type Linestra Incandescent

MAX 150

Single Contact Double S14S Base Lamp With Model

LN120SI.

Turn off power to the fixture.

Push the lamp so the contacts snap into the sockets.

Turn the power to the fixture on.

SWITCH

Install the Lamp

SAVETHESE INSTRUCTIONS!

7400 Linder Ave, Skokie, IL 60077

800.323.3226 - 847.626.6300

www.lbllighting.com

registered trademark of LBL Lighting. LBL Lighting reserves the right to

change specifications for product improvements without notification.

A Generation Brands Company

1717

1 2

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting Linea Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting Linea