Lbl-lighting 2-Circuit MO Direct Feed Canopy Dual Feed Manuel d'utilisateur télécharger pdf

Installation Instructions for

980MR24RDDPFC

4" Round Dual-Post Power Feed Canopy

1.0

REMOTECNPYDIRDF_-2C

GP I :ENERAL RODUCT NFORMATION

This product is suitable for indoor dry locations only.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeter).

Install the Power Feed Canopy

NOTE: The low voltage wires should be present in the

electrical box prior to these steps. Refer to the instructions

provided with the remote transformer to install the remote

transformer and low voltage wires.

Starting with the left post, connect the power feed wire

coming out of the middle contact (the wire coming out of the

knurled cap) to the low voltage wire marked "HOT B1" with a

wire nut.

Connect the center power feed wire (that is attached to the

top contact) to the low voltage wire marked "HOT A1" with a

wire nut.

Connect the remaining side wire to the low voltage wire

marked "COM 1" with a wire nut.

Continue with right post and connect the power feed wire

coming out of the middle contact (the wire coming out of the

knurled cap) to the low voltage wire marked "HOT B2" with a

wire nut.

Connect the center power feed wire (that is attached to the

top contact) to the low voltage wire marked "HOT A2" with a

wire nut.

Connect the remaining side wire to the low voltage wire

marked "COM 2" with a wire nut.

NOTE: Use the provided universal round crossbar when

the canopy holes do not line up with the electrical box

holes.

HOT B1

HOT A1

COM 1

COM 2

HOT A2

HOT B2

WIRE COMING

FROM MIDDLE

CONTACT

WIRE COMING

FROM MIDDLE

CONTACT

TOP CONTACT

CENTER

WIRE

CENTER

WIRE

2-Circuit Monorail

1 2 3 4

Résumé du contenu

Page 1 - Install the Power Feed Canopy

Installation Instructions for980MR24RDDPFC14" Round Dual-Post Power Feed Canopy1.0REMOTECNPYDIRDF_-2CGP I :ENERAL RODUCT NFORMATIONThis product i

Page 2 - Power Feed Canopy

2Place all wires and wire nut connections inside the electricalbox.Tighten the two provided #8-32 flat head screws to theelectrical box holes with the

Page 3

3Place the combined 2-Circuit Monorail sections into thestandoffs and power feed housings so that the straight isolatingconnectors section is located

Page 4 - SAVETHESE INSTRUCTIONS!

Commentaires sur ces manuels

Pas de commentaire

Lbl-lighting 2-Circuit MO Direct Feed Canopy Dual Feed Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Lbl-lighting 2-Circuit MO Direct Feed Canopy Dual Feed. LBL Lighting 2-Circuit MO Direct Feed Canopy Dual Feed User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Lbl-lighting 2-Circuit MO Direct Feed Canopy Dual Feed